Rohde & Schwarz MXO 4 Series - Page 833

Remote control commandsMXO 4 Series
833User Manual 1335.5337.02 ─ 07
Parameters:
<Data_Operator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
*RST: EQUal
Usage: Asynchronous command
Manual operation: See "Edit" on page 417
SBUS<sb>:TNOS:FILTer:ERENable <ErrorName>,<Enabler>
SBUS<sb>:TNOS:FILTer:ERRor<n>:ENABle <Enable>
Suffix:
<sb>
.
1..4
<n> *
Parameters:
<Enable> ON | OFF
*RST: ON
Usage: Asynchronous command
Manual operation: See "Error type" on page 418
SBUS<sb>:TNOS:FILTer:FIENable <Frame>,<Field>,<Enabler>
SBUS<sb>:TNOS:FILTer:FRAMe<fr>:FLD<fl>:ENABle <CondEnabler>
Enables or disables the checking condition for the selected field of the selected frame.
Suffix:
<sb>
.
1...4, index of the serial bus
<fr> index of the frame
<fl> index of the field
Parameters:
<CondEnabler> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Edit" on page 417
SBUS<sb>:TNOS:FILTer:IMAX <Frame>,<Field>,<Data>
SBUS<sb>:TNOS:FILTer:FRAMe<fr>:FLD<fl>:IMAX <Index_Max>
Sets the end value of an index range if the operator is set to INRange.
You can set the operator with SBUS<sb>:TNOS:FILTer:FRAMe<fr>:FLD<fl>:
IOPerator.
Suffix:
<sb>
.
1...4, index of the serial bus
Protocols