Rohde & Schwarz MXO 4 Series - Page 861

Remote control commandsMXO 4 Series
861User Manual 1335.5337.02 ─ 07
Parameters:
<High> Range: -5.99 to 6
Increment: 0.1
*RST: 0.5
Default unit: V
Usage: Asynchronous command
WGENerator<wg>:VOLTage:INVersion <Inversion>
Inverts the waveform at the offset level.
Suffix:
<wg>
.
1...2, index of the waveform generator
Parameters:
<Inversion> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Inversion" on page 431
WGENerator<wg>:VOLTage:LOW <Low>
Sets the low signal level of the output waveform.
Suffix:
<wg>
.
1...2, index of the waveform generator
Parameters:
<Low> Range: -6 to 5.99
Increment: 0.1
*RST: -0.5
Default unit: V
Usage: Asynchronous command
WGENerator<wg>:VOLTage:OFFSet <Offset>
Sets the vertical offset of the generated waveform.
Suffix:
<wg>
.
1...2, index of the waveform generator
Parameters:
<Offset> Range: -5.995 to 5.995
Increment: 0.01
*RST: 0
Default unit: V
Usage: Asynchronous command
Manual operation: See "Offset" on page 437
Waveform generator (option R&S MXO4-B6)