Rohde & Schwarz MXO 4 Series - Page 863

Remote control commandsMXO 4 Series
863User Manual 1335.5337.02 ─ 07
WGENerator<wg>:MODulation:PWM:DCYCle.................................................................. 868
WGENerator<wg>:MODulation:PWM:DEPTh....................................................................869
WGENerator<wg>:MODulation:PWM:FREQuency............................................................ 869
WGENerator<wg>:MODulation:PWM:SYMMetry...............................................................869
WGENerator<wg>:MODulation:PWM[:FUNCtion].............................................................. 870
WGENerator<wg>:MODulation:TYPE.............................................................................. 870
WGENerator<wg>:MODulation[:STATe] <Modulation>
Enables or disables modulation.
Suffix:
<wg>
.
1...2, index of the waveform generator
Parameters:
<Modulation> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Modulation state" on page 439
WGENerator<wg>:MODulation:AM:DCYCle <SquareDutyCycle>
Sets the duty cycle for a square waveform. The duty cycle expresses for what percent-
age fraction of the period, the waveform is active, i.e. the signal state is high.
Suffix:
<wg>
.
1...2, index of the waveform generator
Parameters:
<SquareDutyCycle> Range: 10 to 90
Increment: 1
*RST: 50
Default unit: %
Usage: Asynchronous command
Manual operation: See "Duty cycle" on page 440
WGENerator<wg>:MODulation:AM:DEPTh <Depth>
Sets the modulation depth, the percentage of the amplitude range that is used for AM
modulation.
Suffix:
<wg>
.
1...2, index of the waveform generator
Parameters:
<Depth> Range: 0 to 100
Increment: 1
*RST: 50
Default unit: %
Waveform generator (option R&S MXO4-B6)