Rohde & Schwarz MXO 4 Series - Page 864

Remote control commandsMXO 4 Series
864User Manual 1335.5337.02 ─ 07
Usage: Asynchronous command
Manual operation: See "Depth" on page 440
WGENerator<wg>:MODulation:AM:FREQuency <Frequency>
Sets the frequency of the modulation waveform for AM frequency modulation.
Suffix:
<wg>
.
1...2, index of the waveform generator
Parameters:
<Frequency> Range: 0.001 to 1000000
Increment: 0.001
*RST: 1000
Default unit: Hz
Usage: Asynchronous command
Manual operation: See "Frequency" on page 440
WGENerator<wg>:MODulation:AM:SYMMetry <RampSymmetry>
Sets the symmetry for the AM ramp modulation waveform, the percentage of time that
the waveform is rising.
Suffix:
<wg>
.
1...2, index of the waveform generator
Parameters:
<RampSymmetry> Range: 0 to 100
Increment: 1
*RST: 50
Default unit: %
Usage: Asynchronous command
Manual operation: See "Symmetry" on page 440
WGENerator<wg>:MODulation:AM[:FUNCtion] <SignalType>
Selects the type of the modulating signal for AM modulation.
Suffix:
<wg>
.
1...2, index of the waveform generator
Parameters:
<SignalType> SINusoid | SQUare | RAMP
*RST: SINusoid
Usage: Asynchronous command
Manual operation: See "Signal type" on page 439
Waveform generator (option R&S MXO4-B6)