Rohde & Schwarz MXO 4 Series - Page 867

Remote control commandsMXO 4 Series
867User Manual 1335.5337.02 ─ 07
Parameters:
<SignalType> SINusoid | SQUare | RAMP
*RST: SINusoid
Usage: Asynchronous command
Manual operation: See "Signal type" on page 439
WGENerator<wg>:MODulation:FSK:FONE <Frequency1>
WGENerator<wg>:MODulation:FSK:FTWO <Frequency2>
Sets the frequency of the first /second signal in FSK modulated signal.
Suffix:
<wg>
.
1...2, index of the waveform generator
Parameters:
<Frequency2> Range: 0.001 to 100000000
Increment: 1
*RST: 1000
Default unit: Hz
Usage: Asynchronous command
Manual operation: See "Frequency 1/Frequency 2" on page 440
WGENerator<wg>:MODulation:FSK[:RATE] <Rate>
Sets the frequency at which signal switches between WGENerator<wg>:
MODulation:FSK:FONE and WGENerator<wg>:MODulation:FSK:FTWO.
Suffix:
<wg>
.
1...2, index of the waveform generator
Parameters:
<Rate> Range: 0.001 to 1000000
Increment: 1
*RST: 1000
Default unit: Hz
Usage: Asynchronous command
Manual operation: See "FSK rate" on page 441
WGENerator<wg>:MODulation:NDCLevel <LevelDC>
Sets the DC noise level, if WGENerator<wg>:FUNCtion[:SELect] is set to DC.
Suffix:
<wg>
.
1...2, index of the waveform generator
Waveform generator (option R&S MXO4-B6)