Remote control commandsMXO 4 Series
881User Manual 1335.5337.02 ─ 07
Parameters:
<Value> See Source values for STATus:QUEStionable:...:[:EVENt] and
STATus:QUEStionable:...:[:ENABLe] for a list of the return val-
ues.
Usage: Query only
17.19.6 Controlling the ENABle part
CHANnel<ch>:OVERload:STATus:ENABle <Value>
CHANnel<ch>:ADCState:STATus:NCLipping:ENABle <Value>
CHANnel<ch>:ADCState:STATus:PCLipping:ENABle <Value>
CHANnel<ch>:WARNoverload:STATus:ENABle <Value>
CHANnel<ch>:PPSupply:STATus:ENABle <Value>
MEASurement<mg>:IMPRecise:STATus:ENABle <Value>
MEASurement<mg>:LIMit:STATus:ENABle <Value>
MEASurement<mg>:MARGin:STATus:ENABle <Value>
TRIGger:ACTions:OUT:OVERload:STATus:ENABle <Value>
TRIGger:ANEDge:OVERload:STATus:ENABle <Value>
WGENerator<wg>:GOVerload:STATus:ENABle <Value>
WGENerator<wg>:TEMPerature:STATus:ENABle <Value>
STATus:QUEStionable:ADCState:ENABle <Value>
STATus:QUEStionable:COVerload:ENABle <Value>
STATus:QUEStionable:GOVerload:ENABle <Value>
STATus:QUEStionable:IMPRecise:ENABle <Value>
STATus:QUEStionable:LIMit:ENABle <Value>
STATus:QUEStionable:MARGin:ENABle <Value>
STATus:QUEStionable:PLL:ENABle <Value>
STATus:QUEStionable:PPSupply:ENABle <Value>
STATus:QUEStionable:TEMPerature:ENABle <Value>
Sets the ENABle part that allows true conditions in the EVENt part to be reported for
the summary bit in the status byte.
These events can be used for a service request. If a bit in the ENABle part is 1, and
the corresponding EVENt bit is true, a positive transition occurs in the summary bit.
This transition is reported to the next higher level.
See Source values for STATus:QUEStionable:...:[:EVENt] and STATus:QUEStiona-
ble:...:[:ENABLe] for a list of the return values.
Parameters:
<Value> bit dependent
17.19.7 Controlling the negative transition part
CHANnel<ch>:ADCState:STATus:NCLipping:NTRansition <Value>
CHANnel<ch>:ADCState:STATus:PCLipping:NTRansition <Value>
CHANnel<ch>:OVERload:STATus:NTRansition <Value>
Status reporting
To Next Page
Loading...
