Rohde & Schwarz MXO 4 Series - Deprecated Commands; Base Instrument; Options

Remote control commandsMXO 4 Series
886User Manual 1335.5337.02 ─ 07
“1”. In addition, the test program is blocked while waiting with *OPC?. It is not possible
to process other (not interdependent) commands in the meantime or to communicate
with other instruments.
Thus, for time-consuming operations, you can avoid blocking the communication by
sending the operation complete command *OPC:
*CLS
*OPC
Afterwards you can poll the operation complete status in the event status register with
*ESR?.
This query returns the content of the event status register and afterwards clears the
content. See also Chapter 16.5.3.2, "Event status register (ESR) and event status
enable register (ESE)", on page 466.
17.20 Deprecated commands
The following commands are provided for compatibility to previous oscilloscope ver-
sions only. For new remote control programs, use the specified alternative commands.
17.20.1 Base instrument
Legacy command Replaced by Comment
DIAGnostic:SERVice:COMPutername SYSTem:COMMunicate:NET[:HOSTname]
on page 485
Replaced since FW 2.0
17.20.2 Options
Legacy command Replaced by Comment
SBUS<sb>:SPI:FILTer:ENABle
SBUS<sb>:I2C:FILTer:ENABle
SBUS<sb>:UART:FILTer:ENABle
SBUS<sb>:CAN:FILTer:ENABle
SBUS<sb>:LIN:FILTer:ENABle
- No longer needed since FW 2.0
SBUS<sb>:CAN:DATA:HYSTeresis SBUS<sb>:CAN:SIC:HYSTeresis
on page 764
SBUS<sb>:CAN:FAST:HYSTeresis
on page 765
Replaced since FW 1.4
Deprecated commands