Remote Control - Commands R&S NRP-Z5x
1137.0463.12 6.14 E-7
SYSTem
With the aid of the SYSTem system, administrative device settings can be defined and queried. This
includes detailed information on the sensor and its initialization and the transfer of available commands
and their parameter limits.
Table 6-4 Commands of the SYSTem system
Command Parameter Unit Remarks
SYSTem
:FEATures? Query only
:INFO? [Item] Query only
:INITialize No query
:LIMits? Query only
MINPower? W Query only
RUTime[?] 0.0 to 10.0 s
SUTime[?] 0.0 to 10.0 s
:TRANsaction
:BEGIN: No query
:END No query
SYSTem:FEATures?
This query prompts the sensor to output a complete list of all supported commands and parameters.
This makes it possible to automatically adapt the remote-control software to the features of different
types of sensor with different functionalities.
SYSTem:INFO? [Item]
SYSTem:INFO? yields a string containing information that is more detailed than the identification string
delivered by the sensor as a response to *IDN?. If no Item is specified, the response string is a
sequence of entries in the form Item:Information-String separated by CR and LF (in C notation: \r\n).
With the Item optionally appended to the command, the entry for the required Item can be queried. The
response string is zero-terminated, i.e. its end identification is a zero byte (in C notation: \0).
To Next Page
Loading...
