Instrument Functions
NRP2
122User Manual 1173.9140.02 ─ 07
Define calculation of measurement result:
CALCulate<[1]..8>:FEED<[1]|2>
on page 226
Read result:
FETCh? on page 211
4.5.4.1 Measurement results
The measured values for the selected gate and trace (waveform) are indicated in the
info panel below the graph (see also "Select Trace ..." on page 123).
Average / Peak / Peak/Avg
Average power, peak power and the ratio peak power to average power.
"1 | 2"
Start and stop time of gate.
"Δt"
Duration of gate.
Remote command:
Configuring measurement:
CALCulate<[1]..8>:
FEED<[1]|2>
on page 226
Retrieving results:
FETCh? on page 211
4.5.4.2 Controls in gates display mode
Display
Selects another view, see chapter 4.5.2, "Trace window", on page 114
.
Config Gates ...
Open the subdialog to configure the four available gates, see chapter 4.5.4.3, "Gate
diagram settings", on page 123.
Pos Scale
Defines if the cursor keys position or scale the waveform.
"Pos"
The cursor keys shift the waveform in horizontal and vertical direction
"Scale"
The cursor keys expand and compress the waveform. When the hori-
zontal scaling is modified, the points (pixels) at the left of the screen
remain unchanged. When the vertical scaling is modified, the neutral
zone depends on the unit selected: the points in the center of the
screen remain unchanged when dBm, dB and dBµV are used. The
points at the bottom of the screen remain unchanged in all other dis-
plays.
[1]
[2] [3] [4]
Switches the the function of the cursor keys to altering the borders of a gate.
"[1] [2]"
Shifts the start and stop time.
Displaying traces
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
