Instrument Functions
NRP2
133User Manual 1173.9140.02 ─ 07
Average / Peak / Peak/Avg
Average power, peak power and the ratio peak power to average power.
Remote command:
Configuring measurement:
CALCulate<[1]..8>:FEED<[1]|2>
on page 226
Retrieving results:
FETCh? on page 211
4.5.7.2 Controls in T'Slot display mode
Display
Selects another view, see chapter 4.5.2, "Trace window", on page 114
.
Config T'slots…
Opens the subdialog "Timeslot Config" to configure the timeslot structure, see chap-
ter 4.5.7.3, "T'Slot diagram settings", on page 134.
See also chapter 4.2.1.4, "Measuring the average power of TDMA signals",
on page 68, which describes the measurement of the average power of a TDMA sig-
nal.
Pos Scale
Defines if the cursor keys position or scale the waveform.
"Pos"
The cursor keys shift the waveform in horizontal and vertical direction
"Scale"
The cursor keys expand and compress the waveform. When the hori-
zontal scaling is modified, the points (pixels) at the left of the screen
remain unchanged. When the vertical scaling is modified, the neutral
zone depends on the unit selected: the points in the center of the
screen remain unchanged when dBm, dB and dBµV are used. The
points at the bottom of the screen remain unchanged in all other dis-
plays.
Trigger
Opens the "Trigger"
dialog box. For description refer to chapter 4.2.6, "Trigger set-
tings", on page 85.
Slot
Selects a timeslot for which the power values in the info panel are displayed.
Trace Func ...
Opens the "Trace Function" subdialog, see chapter 4.5.3.4, "Trace function settings",
on page 119.
Displaying traces
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
