Instrument Functions
NRP2
154User Manual 1173.9140.02 ─ 07
Fig. 4-83: Out1 mode / Pass/Fail
Remote command:
OUTPut:TTL[:STATe]
on page 260
Window 1 2 3 4 ← Pass/Fail ← Mode
Selects the window the output refers to.
Only windows that are operated in "Dig" or "D&A" window mode are available for selec-
tion. See chapter 4.3.3.3, "Selecting the result display mode", on page 93 for the set-
ting the display mode.
Remote command:
OUTPut:RECorder<[1]..2>:FEED on page 255
OUTPut:TTL:FEED on page 259
Pass ← Pass/Fail ← Mode
Sets the logic output level for measurement results within the set limits. The value
range is 0 V to 3.3 V.
Remote command:
The setting is achieved by a combination of the following commands. The example is
for OUTPut:TTL:FAIL set to HIGH.
OUTPut:TTL:FAIL on page 258
OUTPut:TTL:HVOLtage on page 259
OUTPut:TTL:ACTive on page 258
Fail ← Pass/Fail ← Mode
Sets the logic output level for limit violation of measurement results. The value range is
0 V to 3.3 V.
Remote command:
The setting is achieved by a combination of the following commands. The example is
for OUTPut:
TTL:FAIL
set to HIGH.
OUTPut:TTL:FAIL on page 258
OUTPut:TTL:LVOLtage on page 259
OUTPut:TTL:ACTive on page 258
TrigOut ← Mode
The output provides a logic signal, which represents the state of the internal trigger
bus.
System settings
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
