Remote Control Fundamentals
NRP2
178User Manual 1173.9140.02 ─ 07
Example:
SENSe2:POWer:TSLot:
COUNt 6
This command sets for sensor 2 the number of timeslots in the Timeslot mode to 6.
Keyword SENSe cannot be omitted.
Long and short form
The keywords have a long and a short form. The keyword may be entered in short or in
long form; other abbreviations are not allowed. The short form uses the first four char-
acters of the long form. If the fourth character is a vowel and the long form consists of
more than four characters, only the first three characters are used for the short form.
The short form is shown by upper-case characters, and the long form is the entire key-
word.
Upper case and lower case notation only serves to distinguish the two forms in the
manual, the instrument itself is case-insensitive.
Example:
STATus:
QUEStionable:
ENABle 1 and STAT:QUES:ENAB 1
Parameters
The parameter must be separated from the header by a white space. If a command
contains several parameters, they have to be separated by a comma (,). Some of the
commands allow the specification of the parameters MINimum, MAXimum and
DEFault. For a description of the parameter types chapter 5.7.5, "Parameters",
on page 180.
Example:
TIMing:EXCLude:STARt? MINimum
Response: 0
This query asks for the minimum setting value.
Numeric suffix
If a device has several identical functions or features, e.g. inputs, the desired function
can be selected by a suffix to the command. Commands without a suffix are interpre-
ted as having a suffix of 1.
Example:
SENSe2:FUNCtion "POWer:AVG"
This command sets the measurement mode of sensor 2 to the ContAv mode.
5.7.3 Structure of a Program Message
A program message may contain one or several commands. Several commands in a
program message are separated by a semicolon (;). If the next command belongs to a
Structure and Syntax of device-dependent Messages
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
