Rohde & Schwarz NRP2 - Correspondence between Remote Control and Manual Control

Remote Control Fundamentals
NRP2
186User Manual 1173.9140.02 ─ 07
SCPI command Value Remark
[SENSe[1..4]]:TIMing:EXCLude:STOP
- Unchanged, is irrelevant.
INITiate[1..4]:CONTinuous ON
Cannot be modified in manual mode.
Mode Timeslot Av
TRIGger[1..4]:SOURce EXTernal |
INTernal
User-selectable.
TRIGger[1..4]:SLOPe POSitive |
NEGative
User-selectable.
TRIGger[1..4]:COUNt 1
Cannot be modified in manual mode.
TRIGger[1..4]:DELay
Depends on sensor User-selectable.
TRIGger[1..4]:HOLDoff
Depends on sensor User-selectable.
TRIGger[1..4]:LEVel
Depends on sensor User-selectable.
[SENSe[1..4]]:TIMing:EXCLude:
STARt
- Unchanged, is irrelevant.
[SENSe[1..4]]:TIMing:EXCLude:STOP
- Unchanged, is irrelevant.
INITiate[1..4]:CONTinuous ON
Cannot be modified in manual mode.
Mode Trace & Statistics
TRIGger[1..4]:SOURce EXTernal |
INTernal
User-selectable.
TRIGger[1..4]:SLOPe POSitive |
NEGative
User-selectable.
TRIGger[1..4]:COUNt
1 Cannot be modified in manual mode.
TRIGger[1..4]:DELay 0 S
Cannot be modified in manual mode.
TRIGger[1..4]:HOLDoff
Depends on sensor User-selectable.
TRIGger[1..4]:LEVel
Depends on sensor User-selectable.
[SENSe[1..4]]:TIMing:EXCLude:
STARt
0 S
Cannot be modified in manual mode.
[SENSe[1..4]]:TIMing:EXCLude:STOP 0 S
Cannot be modified in manual mode.
INITiate[1..4]:CONTinuous ON
Cannot be modified in manual mode.
5.10 Correspondence between Remote Control and Man-
ual Control
The following table compares the control elements of the graphical user interface for
manual control with the SCPI commands for remote control in order to simplify the
transfer of manual control procedures to a remote control program.
Correspondence between Remote Control and Manual Control
北京海洋兴业科技股份有限公司（证券代码：839145）
电话：010-62176775
网址：www.hyxyyq.com