Remote Control - Commands
NRP2
194User Manual 1173.9140.02 ─ 07
Example:
Definition: OUTPut:AUDiobits <audiobits>
Command:
OUTP:AUD 24
Special characters | and { }
|
A vertical bar in parameter definitions indicates alternative possibilities in the sense of
"or". The effect of the command differs, depending on which parameter is used.
Example:
Definition: INITiate:
CONTinuous
ON | OFF
Command INITiate:CONTinuous ON starts the measurements
Command INITiate:CONTinuous OFF stops the measurements
{ } Parameters in braces may be included in the command once, several times or not at all.
6.1.1 Parameter Types
<NR1> Stands for integers with sign.
Examples:
●
1
●
-33
●
32767
<NRf> Stands for floating point numbers that can also be written in exponential notation.
Examples:
●
1
●
1.0
●
-21.2345553e-6
<int_value> Is an abbreviation for <NR1>|MINimum|MAXimum|DEFault.
<float_value> Is an abbreviation for <NRf>|MINimum|MAXimum|DEFault.
<boolean> Stands for ON|OFF|0|1, where ON and 1 are identical in meaning as are OFF and 0.
<string> Stands for character strings that have to be within single or double quotes.
Examples:
●
'free text'
●
"Sirius"
<block_data> Stands for block data (chapter 5.7.5, "Parameters", on page 180
).
<non-deci-
mal_numeric>
Is a non-decimal value in one of the following representations:
●
binary (e. g. #b0111010101001110 or #B0111010101001110)
●
hexadecimal (e.g. #h754e or #H754E)
●
octal (e.g. #q72516
or #Q75216)
6.2 Common Commands to IEEE 488.2
The common commands are taken from the IEEE 488.2 (IEC 625–2) standard. Some
commands have the same effect on different devices. The headers of these com-
mands consist of an asterisk "*" followed by three letters. Many common commands
Common Commands to IEEE 488.2
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
