Remote Control - Commands
NRP2
204User Manual 1173.9140.02 ─ 07
Command Preset and *RST value Remark
SYST:STAN:TRIG:SOUR INT
Internal triggering.
TRIG:ALL:SYNC OFF
TRIG[1..4|:ALL]:ATR ON | OFF
Depending on sensor.
TRIG[1..4|:ALL]:COUN <NR1>
Depending on sensor.
TRIG[1..4|:ALL]:DELay <NRf>
Depending on sensor.
TRIG[1..4|:ALL]:DEL:AUTO ON | OFF
Depending on sensor.
TRIG[1..4|:ALL]:DTIM <NRf>
Depending on sensor.
TRIG[1..4|:ALL]:HOLD <NRf>
Depending on sensor.
TRIG[1..4|:ALL]:HYST <NRf>
Depending on sensor.
TRIG[1..4|:ALL]:LEV <NRf>
Depending on sensor.
TRIG[1..4|:ALL]:MAST ON | OFF
Depending on sensor.
TRIG[1..4|:ALL]:SLOP POS | NEG
Depending on sensor.
TRIG[1..4|:ALL]:SOUR IMM | HOLD | EXT |
INT | BUS
Depending on sensor.
UNIT<[1]..8>:POW DBM
Logarithmic result scaling.
UNIT<[1]..8>:POW:RAT DB
Logarithmic result scaling.
Usage: Event
*SAV <value>
SAVe stores the current device state under the specified number.
Parameters:
<Value> 1 to 19
Available storage numbers for device setups.
Usage: Event
*SRE <value>
Setting command: *SRE
Service Request Enable sets the service request enable register to the specified value.
Bit 6 (MSS mask bit) remains 0. This command determines under which conditions a
service request is generated.
Query: *SRE
The query form *SRE? reads the contents of the service request enable register in
decimal form. Bit 6 is always 0.
Parameters:
<value> 0 to 255
Common Commands to IEEE 488.2
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
