Remote Control - Commands
NRP2
212User Manual 1173.9140.02 ─ 07
Usage: Query only
6.4.3 Syntactical Structure of High-Level Measurement Commands
The high-level measurement commands can be generally represented as follows:
<head><meas_mode>[<calc_function>][?]
<parameter_list>
Table 6-5: Syntactical Structure of High-Level Measurement Commands
<head>
<head> = These keywords select the high level command subsystem.
Command keywords
●
CONFigure<[1]..8>
●
FETCh<[1]..8>
●
MEASure<[1]..8>
●
READ<[1]..8>
<meas_mode>
<meas_mode> = These keywords select the measurement mode ( ContAv, ContAv
with data buffering, Burst, Timeslot, Trace, or Statistics, see also low lwvwl command
[SENSe<[1]..4>]:FUNCtion[:
ON] on page 269).
Command keywords
●
[:SCALar][:POWer][:AVG] (ContAv mode)
●
[:SCALar][:POWer]:TSLot (T'slot mode)
●
[:SCALar][:POWer]:BURSt (Burst mode)
●
:ARRay[:POWer][:AVG] (ContAv with data buffering mode)
●
:XTIMe[:POWer] (Trace mode)
●
:STATistics:CCDF (Statistics mode)
●
:STATistics:PDF Statistics mode)
<calc_function>
<calc_function> = These keywords select the calculation function, see also the low
level commandCALCulate<[1]..8>:
MATH[:EXPRession] on page
231). If
<calc_function> is not specified, the measured value of the primary channel is output.
Command keywords
●
:RELative
●
:DIFFerence
●
:DIFFerence:RELative
●
:SUM
●
:SUM:RELative
●
:RATio
●
:RATio:RELative
●
:RLOSs
●
:SWR
●
:REFLection
[?]
The "?" terminates the measurement commands which are always queries. Measure-
ment commands are the FETCh:...?, READ:
...?
and MEASurement:...? com-
mands.
<param_list>
A list with parameters is sent with the high level command. The meaning of the
parameters is determined by the <meas_mode>, see chapter 6.4.4, "Parameter list
description", on page 212.
6.4.4 Parameter list description
Six different parameter lists are used in the high end measurement commands. Which
list is used depends on the selected measurement mode. The elements of these lists
can be omitted starting at the end and working backward. They will then be replaced
by their default values.
High-Level Measurement Commands (CONFigure, MEASure, READ and FETCh)
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
