Putting into Operation
NRP2
19User Manual 1173.9140.02 ─ 07
1.8.2.1 Start screen
Immediately after turning on the start screen appears, and the R&S NRP2 provides
short-term access to the boot menu and the firmware update menu.
The bootmenu provides service and system functions, e.g. resetting the internal mem-
ory, see chapter 8.3, "Bootmenu", on page 346
For further information on the firmware update see firmware release notes on the R&S
website available for download: http://www.rohde-schwarz.com/product/NRP2.html.
Fig. 1-8: Start screen with access to Firmware Update and Bootmenu
1.8.2.2 Function check
After switch-on, the R&S NRP2 performs a function test. The contents of all non-vola-
tile memories, the RAM and the addressability of the interfaces are checked. Mes-
sages indicate the options the instrument is equipped with.
The R&S NRP2 checks the following functions:
●
Function test on the RAM
●
Function test on the keyboard controller
●
Addressability check on the keypad
●
Addressability check on the test generator.
This test is performed if the instrument is equipped with option R&S NRP-B1/B7,
sensor check source.
●
Addressability check of the sensor channels
Depending on the number of installed sensors, the displayed icon varies:
Fig. 1-9: Connected sensors (symbols)
– One of the sensor boxes shown on the left bottom of the icon represents a sen-
sor connected at channel A, i.e. the instrument is single channel.
Starting the R&S NRP2
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
