Rohde & Schwarz NRP2 - Page 232

Remote Control - Commands
NRP2
229User Manual 1173.9140.02 ─ 07
Table 6-10: Value ranges, depending on the unit
Unit of mea-
sured value
W DBM DBUV DPCT DB O
Value range -9.99999E5
..
9.99999E5
-120
..
90
-13.0103
..
196.897
-100
..
999.99
-200
..
200
-1E20
..
1E20
CALCulate<[1]..8>:LIMit:LOWer[:DATA]:POWer <lower_limit>
Sets a lower limit for the measured power. The R&S NRP2 can respond when the val-
ues drop below this limit (see other CALCulate<[1]..8>:LIMit commands).
Parameters:
<lower_limit>
float_value; units: W | DBM | DBUV
Range: -120 DBM to 90 DBM
*RST: 0 DBM
Default unit:
DBM
CALCulate<[1]..8>:LIMit:LOWer[:DATA]:RATio <ratio>
Sets a lower limit for the measured power ratios. The R&S NRP2 can respond when
the ratios drop below this limit (see other CALCulate<[1]..8>:LIMit commands).
Parameters:
<ratio> float_value; units: DB | DBCT | O
Range:
-200 DB to 200 DB
*RST: 0 DB
Default unit:
DB
CALCulate<[1]..8>:LIMit:LOWer:STATe <state>
Switches the monitoring function for theupper and lower limit on or off.
Parameters:
<state> ON | OFF
*RST: OFF
Usage: Setting only
CALCulate<[1]..8>:LIMit:STATe <state>
Switches the monitoring function for the upper limit on or off.
Parameters:
<state> ON | OFF
*
RST: OFF
Usage: Setting only
CALCulate (Configuration of Calculate Blocks)
北京海洋兴业科技股份有限公司（证券代码：839145）
电话：010-62176775
网址：www.hyxyyq.com