Remote Control - Commands
NRP2
234User Manual 1173.9140.02 ─ 07
Parameters:
<auto> OFF | ONCE
*RST: OFF
CALCulate<[1]..8>:RELative:POWer[:MAGNitude] <value>
Has the same direct effect as CALC:
REL
on the reference value for measured values
that share the unit of a power.
Parameters:
<value> float_value, units: DBM | W
Range: 1e-18..1e18 W | -150..210 DBM
*RST: 0 DBM
Default unit:
DBM
CALCulate<[1]..8>:RELative:RATio[:MAGNitude] <value>
Has the same direct effect as CALC:REL on the reference value for measured values
that share the unit of a power ratio.
Parameters:
<value> float_value, units: DB | PCT
Range: -200..200 DB | 1e-18..1e22 PCT
*RST: 0 DB
Default unit:
DB
CALCulate<[1]..8>:RELative:STATe <state>
Determines whether a reference value is used. If this command is called with ON, all
results of the calculate block are divided by the reference value set with
CALCulate[1..8]:RELative[:
MAGNitude].
Parameters:
<state> ON | OFF
ON
all results of the calculate block are divided by the reference
value set with
CALCulate<[1]..8>:RELative[:
MAGNitude].
OFF
a reference value is not used.
*RST: OFF
CALCulate<[1]..8>:SDEViation:DATA?
Queries the standard deviation σof all measured values of the calculate block. The
standard deviation is calculated together with the mean value and reset. The following
formula applies:
CALCulate (Configuration of Calculate Blocks)
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
