Remote Control - Commands
NRP2
236User Manual 1173.9140.02 ─ 07
Power
CALC:STAT:MARK:HOR:DATA?
CALC:STAT:MARK:VERT:POS:Y
Density/Distribution
CALC:STAT:MARK:HOR:POS:X:POW
CALC:STAT:MARK:VERT:DATA:POW?
Fig. 6-7: Meaning of the marker commands for the Statistics mode
Usage: Query only
CALCulate<[1]..4>:STATistics:POWer:AVG:DATA?
Returns the average value of the power in the time window of a statistics measure-
ment. The time window is defined with the sensor commands SENS:STAT:TIME,
SENS:
STAT:OFFS, SENS:STAT:MID:TIME and SENS:STAT:MID:OFFS:TIME.
Units: DBM | W | DBUV
Usage: Query only
CALCulate<[1]..8>:TRACe:MARKer:XDELta?
Is available with trace measurements. It returns the time difference of the two curve
markers if the value is valid.
Usage: Query only
CALCulate<[1]..8>:TRACe:MARKer:YDELta?
Is available with trace measurements. It returns the power difference of the two curve
markers if the value is valid. The unit depends on the trace function.
Usage: Query only
Units: W (for trace function SINGLE) | DB (for trace function RATIO)
CALCulate<[1]..8>:TRACe:MARKer<[1]..2>:XPOSition
Is available with trace measurements. It sets or sets or returns the position of a curve
marker on the time axis.
CALCulate (Configuration of Calculate Blocks)
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
