Remote Control - Commands
NRP2
309User Manual 1173.9140.02 ─ 07
Table 6-23: Meaning of bits used in the Operation Calibrating Status Register
Bit No. Meaning
0 Not used
1 Sensor A is being calibrated
2 Sensor B is being calibrated
3 Sensor C is being calibrated
4 Sensor D is being calibrated
5 to 14 Not used
15 Bit 15 will never be used.
6.13.12 Operation Measuring Status Register
The CONDition register contains information as to whether a measurement is being
performed by a sensor and, depending on the configuration of the transition register,
the EVENt register indicates whether a measurement was started or completed since
the last readout of this register.
The Operation Measuring Status Register can be read by the following commands:
STATus:OPERation:
MEASuring[:
SUMMary]:CONDition?
STATus:OPERation:MEASuring[:SUMMary][:EVENt]?.
Table 6-24: Meaning of bits used in the Operation Measuring Status Register
Bit No. Meaning
0 Not used
1 Sensor A measuring
Sensor A is performing a measurement.
2 Sensor B measuring
Sensor B is performing a measurement.
3 Sensor C measuring
Sensor C is performing a measurement.
4 Sensor D measuring
Sensor D is performing a measurement.
5 to14 Not used
15 Bit 15 will never be used.
6.13.13 Operation Trigger Status Register
The CONDition register contains information as to whether a sensor is currently in the
WAIT_FOR_TRG state, i.e. expecting a trigger event and, depending on the configura-
tion of the transition register, the EVENt register indicates whether the
STATus
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
