Remote Control - Commands
NRP2
310User Manual 1173.9140.02 ─ 07
WAIT_FOR_TRG state was entered or quit by a sensor since the last readout of the
register.
The Operation Trigger Status Register can be read by the following commands:
STATus:
OPERation:
TRIGger[:SUMMary]:CONDition?
STATus:OPERation:TRIGger[:SUMMary][:EVENt]? .
Table 6-25: Meaning of bits used in the Operation Status Register
Bit No. Meaning
0 Not used
1 Sensor A waiting for trigger
Sensor A is in the WAIT_FOR_TRG state and is waiting for a trigger event that will change
it to the MEASURING state.
2 Sensor B waiting for trigger
Sensor B is in the WAIT_FOR_TRG state and is waiting for a trigger event that will change
it to the MEASURING state.
3 Sensor C waiting for trigger
Sensor C is in the WAIT_FOR_TRG state and is waiting for a trigger event that will change
it to the MEASURING state.
4 Sensor D waiting for trigger
Sensor D is in the WAIT_FOR_TRG state and is waiting for a trigger event that will change
it to the MEASURING state.
5 to 14 Not used
15 Bit 15 will never be used.
6.13.14 Operation Sense Status Register
The CONDition register contains information as to whether a sensor is currently being
initialized and, depending on the configuration of the transition register, the EVENt reg-
ister indicates whether a sensor initialization was started or completed since the last
readout of this register.
This status is assumed by a sensor if one of the following conditions is met:
●
the supply voltage is switched on (power up)
●
the sensor was just connected
●
a reset was performed (*RST or SYSTem:
PRESet
)
The Operation Sense Status Register can be read by the following commands:
STATus:OPERation:SENSe[:SUMMary]:CONDition?
STATus:OPERation:SENSe[:SUMMary][:EVENt]?
STATus
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
