Remote Control - Commands
NRP2
323User Manual 1173.9140.02 ─ 07
<string_value> Meaning
"BootloadVer"
Version of boot loader
"KeybCtrlVer"
Version of keyboard controller
"Options"
Installed options
"MACAddr"
MAC address of the R&S NRP2 if Ethernet option has been installed
"RAMSize"
RAM size
"ROMSize"
ROM size
"CPUClock"
Clock frequency of processor
"CPLDVersion"
Version of CPLD chip
"PICVersion"
Version of PIC-Chip
Parameters:
<string> string_value
Usage: Query only
SYSTem:ERRor?
This query returns error numbers and text from the error/event queue of the
R&S NRP2. A specific error number with text is entered in the error/event queue for
each error that occurs in the R&S NRP2. The queue functions according to the FIFO
principle. The message entered first in the queue is also output first when a
SYST:ERR? query is sent. Querying clears the message.
Up to 30 errors can be stored in the error/event queue. If further errors occur, the most
recent error is overwritten by the message -350, "Queue overflow".
If the error/event queue is empty, the message 0, "No error" is returned as a response.
The queue is cleared by *CLS. It is not changed by*RST.
For further information on the error/event queue see chapter 6.13, "STATus",
on page
296.
Usage: Query only
SYSTem:ERRor:EXTended[:STATe] <state>
SYST:ERR:EXT ON
activates extended error messages (SYST:ERR?). The location of
errors in the parsed command strings is also shown.
Parameters:
<state> ON | OFF
*RST: OFF
SYSTem
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
