Remote Control - Commands
NRP2
335User Manual 1173.9140.02 ─ 07
Parameters:
<state> BUS | EXTernal | HOLD | IMMediate | INTernal
BUS
The trigger event is initiated by TRIG:IMM or *TRG. In this case,
the other trigger setting are meaningless.
EXTernal
Triggering is performed with an external signal applied to the
trigger connector. The TRIG:SLOP command determines
whether the rising or the falling edge of the signal is to be used
for triggering. Waiting for a trigger event can be skipped by
TRIG:IMM.
HOLD
A measurement can only be triggered when the command
TRIG:IMM is executed.
IMMediate
The sensor does not remain in the WAIT_FOR_TRG state but
immediately changes to the MEASURING state.
INTernal
The sensor determines the trigger time by means of the signal to
be measured. When this signal exceeds (TRIG:SLOP
POS
) or
fall short of (TRIG:SLOP NEG) the power set by TRIG:LEV, the
measurement is started after the time set by TRIG:DEL. Similar
to TRIG:SOUR EXT, waiting for a trigger event can also be skip-
ped by TRIG:IMM.
*RST: depending on sensor
TRIGger<[1]..4>:SYNChronize[:STATe] <state>
If set to ON, the command blocks the external trigger bus as long as the sensor is not in
WAIT_FOR_TRIGGER state. It is usually used in combination with command
TRIG:MAST and makes certain, that a new measurement will only be started after all
sensors have completed their last measurement.
Parameters:
<state> ON | OFF
*RST: depending on sensor
6.16 UNIT
Commands of the UNIT system
UNIT<[1]..8>:POWer
...................................................................................................... 336
UNIT<[1]..8>:POWer:RATio............................................................................................ 336
UNIT
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
