Getting Started
NRP2
32User Manual 1173.9140.02 ─ 07
Fig. 2-7: Sensor menu
All sensor-related settings are made in the "Sensor" menu. It determines type and
details of data acquisition.
2. Press the left side of the "Offset…"
softkey.
The "Offset" dialog box opens. Offsets in dB for compensating external signal los-
ses or gains, for example by attenuator or amplifiers, can be set in this dialog box.
Fig. 2-8: Offset dialog box
3. Activate the entry for the global offset.
Positive values are for correcting losses and negative values for gains.
4. If you have an attenuator at hand, enter its value and connect the attenuator
between the sensor and the signal source, otherwise just enter 10
dB.
5. Confirm the entry with ↵MENU.
6. Activate the global offset correction by pressing the right side of the associated
softkey.
Measuring average power (Cont Av mode)
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
