Instrument Functions
NRP2
81User Manual 1173.9140.02 ─ 07
4.2.3.1 Filter dialog box
Fig. 4-16: Filter dialog box
A | B | C | D
Tabs for selecting the sensor.
Note: In remote-control commands, select the sensor with the suffix in command
SENSe<[1]..4>:...
, i.e. choose suffix 1 for channel A, channel 2 for B, and so on.
Auto
Toggles between automatic and manual filter setting.
Remote command:
[SENSe<[1]..4>]:AVERage:
COUNt:AUTO on page 264
Avg No
Sets the averaging number manually.
This entry field always shows the current averaging number. With automatic averaging,
the displayed value is grayed out and cannot be changed manually. If manual filtering
is selected, the desired averaging number can be set. Changes are immediately imple-
mented when a key is pressed.
Remote command:
[SENSe<[1]..4>]:
AVERage:
COUNt on page 263
Reset
Initializes the currently measured averaging filter power value. Thus, the display can be
updated quickly after a change in level, particularly in the case of a large averaging
number.
Remote command:
[SENSe<[1]..4>]:
AVERage:
RESet on page 266
Auto Once
Determines a “one-off” optimal averaging number based on the instantaneously mea-
sured power value and enter this value in the "Avg No" field. This function is available
when autofilter is off.
Remote command:
[SENSe<[1]..4>]:
AVERage:COUNt:AUTO on page 264
Data acquisition and parameters
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
