Remote Control Commands
R&S
®
NRPxxA(N)
93User Manual 1177.6017.02 ─ 05
In this situation, previous measurement results, which are still contained in the averag-
ing filter, strongly affect the settling of the display. As a result, the advantage of detect-
ing trends in the measurement result while the measurement is still in progress is lost.
Example:
AVER:RES
Usage: Event
[SENSe<Sensor>:]AVERage:COUNt:AUTO:TYPE <type>
Sets the automatic averaging filter mode.
Parameters:
<type> RESolution | NSRatio
RESolution
The usual mode for the power sensors.
NSRatio
Predefines the compliance to an exactly defined noise compo-
nent.
*RST: RESolution
Manual operation: See "<Mode>" on page 50
[SENSe<Sensor>:]AVERage:TCONtrol <mode>
Defines how the measurement results are output. This is called termination control.
See also Chapter 9.5, "Controlling the Measurement", on page 71.
Parameters:
<mode> MOVing | REPeat
MOVing
Outputs intermediate values to facilitate early detection of
changes in the measured quantity. In the settled state, that
means when the number of measurements specified by the
average count has been performed, a moving average is output.
REPeat
Specifies that a measurement result is not output until the entire
measurement has been completed. This means that the number
of measurement cycle repetitions is equal to the set average
count. If the average count is large, the measurement time can
be very long.
The average count is set using [SENSe<Sensor>:]AVERage:
COUNt on page 91.
*RST:
REPeat
Example:
AVER:TCON REP
Manual operation: See "Filter Terminal Control" on page 51
Configuring Basic Measurement Parameters
To Next Page
Loading...
