Rohde & Schwarz PR100 - Page 119

R&S PR100 User Manual
d
DISPlay
. :LEVel
. . :LIMit
. . . :MINimum? [MINimum|MAXimum]
Query of lower limit for the level-bar display
This setting only applies if the tone mode if off (OUTP:TONE:STAT OFF). If
tone mode is on, the device determines the lower limit itself.
Parameter:
none query of current signal-level in dBZV
MINimum|MAXimum query of lowest|highest signal-level
Result:
signal-level in dBZV
Example:
DISPlay:LEVel:LIMit:MINimum? -> 20
d
DISPlay
. :LEVel
. . :RANGe <numeric_value>|MINimum|MAXimum
Sets the range of signal levels that is displayed in a level-bar view. Different
levels within this range can be distinguished in the panorama view. The top-
end of the range is equal to “DISP:LEV:LIM:MIN”.
This setting only applies if the tone mode if off (OUTP:TONE:STAT OFF). If
tone mode is on, the device determines the lower limit itself.
Parameters:
<numeric_value> signal-level range in dBZV
MINimum|MAXimum minimum|maximum range
Remark:
The range can be set in discrete steps. Intermediate values are therefore
rounded to the nearest discrete value.
Example:
DISPlay:LEVel:RANGe 30