Rohde & Schwarz PR100 - Page 148

R&S PR100 User Manual
MEM:SAVE:AUTO:STOP). This setting is ignored in case the squelch is off
(see OUTP:SQU:STAT).
Parameters:
<mem_loc> 0...1023
Example:
MEMory:SAVE:AUTO:STARt 120
MEMory
. :SAVE
. . :AUTO
. . . :STARt?
Query of first memory location for auto save
Parameter:
none
Result:
0...1023
Example:
MEMory:SAVE:AUTO:STARt? -> 120
MEMory
. :SAVE
. . :AUTO
. . . :STOP <mem_loc>
Sets the last memory location that is used to save receiver settings when
automatic save on squelch is active (see OUTP:SQU:STOR). The first
location is set with MEM:SAVE:AUTO:STAR. A stop location that is smaller
than the start location is rejected with error -221(“Settings conflict”).
Parameters:
<mem_loc> 0...1023
Example:
MEMory:SAVE:AUTO:STOP 180
MEMory
. :SAVE
. . :AUTO
. . . :STOP?
Query of the last memory location used for auto save.
Parameter:
none