Rohde & Schwarz PR100 - Page 197

R&S PR100 User Manual
[SENSe]
. :GCONtrol
. . [:FIXed|MGC]? [MINimum|MAXimum]
Query of the MGC value.
Parameters:
none query of current MGC value
MINimum|MAXimum query of smallest|largest MGC value
Result:
Gain control
Example:
GCONtrol? -> 50
[SENSe]
. :GCONtrol
. . [:FIXed|MGC]
. . . :STEP
. . . . [:INCRement] <numeric_value>|MINimum|MAXimum
Setting the stepwidth for the command SENSe:GCONtrol[:FIXed|MGC]
UP|DOWN.
Parameters:
<numeric_value> MGC stepwidth
MINimum|MAXimum smallest|largest stepwidth
Example:
GCONtrol:STEP 10