R&S PR100 User Manual
Sense Frequency Scan subsystem SWE
The SWEep system controls the frequency function of the device if the
frequency scan has been activated by the SENSe:FREQuency:MODE
SWEep command. Each scan is initiated by INITiate[:IMMediate].
[SENSe]
. :SWEep
. . :CONTrol
. . . :OFF <control _function> {,<control_function>}
Command for switch-off of the STOP:SIGNalfunctions. See also
SENS:SWE:CONT:ON. This value is mapped onto the same variable as the
memory scan control mechanism variable, meaning that a change affects both
scan modes.
Parameters:
<control_function> is the following string:
"STOP:SIGNal" switch-on signal-controlled dwell-time
*RST state:
after *RST, all control mechanisms are on
Example:
SWEep:CONTrol:OFF "STOP:SIGN"
[SENSe]
. :SWEep
. . :CONTrol
. . . :OFF?
Query of switched-off scan-control functions.
Parameters:
none
Result:
List of switched-off control functions. If no function is inactive, a zero string ("")
is output. The following strings are to be expected:
"STOP:SIGN" signal-controlled dwell-time switched off
"" zero string : no function is active
Example:
SWEep:CONTrol:OFF? -> "STOP:SIGN"
To Next Page
Loading...
