Rohde & Schwarz PR100 - 11.15 STATus subsystem

R&S PR100 User Manual
d
[SENSe]
. :SWEep
. . :SUPPress
Insert current frequency into suppress list. The range is obtained from the
bandwidth according to the following formulae:
SSTARTn = SENSn:FREQ - SENSn:BAND/2
SSTOPn = SENSn:FREQ + SENSn:BAND/2
The frequency pair is inserted into an empty space of the trace. Free spaces
(gaps) are characterized by a frequency pair with each having the value 0
(zero).
Error:
If the corresponding suppress trace has no free space, an error -223 "Too
much data" is generated.
Parameters:
none
Example:
SWEep:SUPPress
d
[SENSe]
. :SWEep
. . :SUPPress
. . . :SORT
Sort and condense suppress list. The frequency pairs are sorted in ascending
order of the start frequency. Overlapping is eliminated by extending one
frequency pair, and deleting the other. Gaps in the suppress list are put to the
end of the list.
Parameters:
none
Example:
SWEep:SUPPress:SORT
11.15 STATus subsystem
The following extended STATus register commands are available:
STATus
. :EXTension
. . :CONDition?
. . :ENABle <numeric_value>
. . :ENABle?
. . [:EVENt]?
. . :NTRansition <numeric_value>
. . :NTRansition?