Rohde & Schwarz PR100 - Page 224

R&S PR100 User Manual
Remark:
Leading zero’s are not displayed.
Result:
The FORMat:SREGister command determines the output format.
Example:
STATus:OPERation:CONDition? -> #H8
STATus
. OPERation
. . :ENABle <numeric_value>
Setting the enable section of the OPERation status register.
Parameters:
<numeric_value> value of the enable section
(e.g. 0..65535 or #H0..#HFFFF)
*RST state:
will not be changed by *RST
Example:
STATus:OPERation:ENABle #H8
STATus
. OPERation
. . :ENABle?
Query of the enable section of the OPERation status register.
Parameters:
none
Remark:
Leading zero’s are not displayed.
Result:
The FORMat:SREGister command determines the output format.
Example:
STATus:OPERation:ENABle? -> #H8
STATus
. OPERation
. . [:EVENt]?
Query of the event section of the OPERation status register.
Parameters:
none