Rohde & Schwarz PR100 - Mscan

R&S PR100 User Manual
Table 27: FScan Data Types
Terminal C Data Type Remarks
<FScan cycle count> short Output of “SENS:SWE:COUN?”
Range: [1, 1000]
Infinity: 1001
<FScan hold time> short Output of
“SENS:SWE:HOLD:TIME?” in
ms
<FScan dwell time> short Output of “SENS:SWE:DWEL?”
in ms
Infinity: 65535 (0xFFFF)
<FScan direction up> short Output of “SENS:SWE:DIR?”
acc. to
1 = Increasing frequency
0 = Decreasing frequency
<FScan stop signal> short Output of
“SENS:SWE:CONT:ON?” acc,
to
0 = Off
1 = On
<FScan start frequency
low>
unsigned long Lower 32 bits of output of
“SENS:FREQ:STAR?” in Hz
<FScan stop frequency
low>
unsigned long Lower 32 bits of output of
“SENS:FREQ:STOP?” in Hz
<FScan frequency step> unsigned long Output of
“SENS:FREQ:STEP:INCR?” in
Hz
<FScan start frequency
high>
unsigned long Upper 32 bits of output of
“SENS:FREQ:STAR?” in Hz
<FScan stop frequency
high>
unsigned long Upper 32 bits of output of
“SENS:FREQ:STOP?” in Hz
12.4 MScan
The Orion MR can provide 2000 measurements per second (minimum
MEAS:TIME is 0.5 ms; Req. SFD0172). For each measurement, LEVEL,
OFFSET, FSTRENGTH, CHANNEL, FREQ_LOW and FREQ_HIGH can be
included into this stream, which is 18 bytes per measurement.
All selector flags (see Table 20) are applicable for this stream
Data are output when MSCAN is running.
Table 28: MScan Format <optional header> and <trace data>.
32-bit aligned 8-bit aligned 16-bit aligned 8-bit aligned