Rohde & Schwarz PR100 - Change Bit-Allocation in Status:extension Register

R&S PR100 User Manual
Bit
No.
Meaning
14 PSCAN configuration changed
This bit is set if the PSCAN data-set is changed by manual control or
by another remote client. See also Table 8.
With bits 0 to 2 and 7 to 9 and 12 to 14, the host can be informed via an SRQ
about parameter changes. Cyclical polling of the settings by the host is thus
stopped during manual operation or if the signal parameters are to be
indicated. In the CONDition section of the register, the change bits are set
after manual control or signal change and are reset by special query
commands. Changes done by front panel or by another remote client affect
the change bits equally.
Table 8: Change bit-allocation in STATus:EXTension register
Bit
No.
Set by change of: Reset by query:
0 Frequency, demodulation,
bandwidth, threshold value, MGC
value, control mode, antenna
number, attenuation, type of
detector, squelch enable, squelch
control, sensor function, AFC,
TONE mode, tone reference
threshold, AUX bit(s), AUX output
mode, IF-panorama display width,
IF-panorama display mode,
measuring time
FREQ?, DEM?, BAND?,
GCON:MODE?, INP:ATT:STAT?,
DET?, OUTP:SQU?,
OUTP:SQU:CONT?, FUNC?,
FREQ:AFC?, RX, OUTP:TONE?,
OUTP:TONE:THR?,
OUTP:BYTAux?, OUTP:AUX?,
CALC:IFPAN:AVERTYPE?,
CALC:IFPAN:AVER:TIME?,
MEAS:TIME?
1 FSCAN:
Start frequency, stop frequency,
stepwidth, number of
SWE:HOLD:TIME?, runs,
synchronizing time, listening time,
scan mode
FREQ:STAR?, FREQ:STOP?,
SWE:STEP?, SWE:COUN?,
SWE:DWEL?, SWE:DIR?,
SWE:CONT?
2 Signal level, offset SENS:DATA?
7 Display variants, display mode,
display disable, antenna names,
display illumination cut-out time,
display brightness
DISP:CMAP?, DISP:BRIG?,
8 Volume, loudspeaker, balance,
external reference, tone
monitoring
SYST:AUD:VOL?,
SYST:AUD:BAL?,
ROSC:SOUR?,
OUTP:TONE:CONT?
9 MSCAN:
Number of runs, synchronizing
time, listening time, scan mode
MSC:COUN?, MSC:DWEL?,
MSC:HOLD:TIME?, MSC:DIR?;
MSC:CONT?