Rohde & Schwarz PR100 - 9.3 Error Messages

R&S PR100 User Manual
Error code from queue
query
Error explanation
-128,"Numeric data not
allowed"
The command contains a number which is not
allowed at this position. Example: Command
FORMat:BORDer requires the indication of a
text parameter.
-
131,"Invalid suffix"
The suffix is invalid for this instrument. Example:
nHz is not defined.
-134,"Suffix too long
"
The suffix contains more than 12 digits.
-
138,"Suffix not allowed"
A suffix is not allowed for this command or at
this position of the command.
-141,"Invalid character
data"
The text parameter either contains an invalid
sign or it is invalid for this command. Example:
spelling mistakes during parameter indication;
FORMat:BORder WASP
-144,"Character data too
long"
The text parameter contains more than 12
characters.
-148,"Character data not
allowed"
The text parameter is not allowed for this
command or at this position of the command.
-
151,"Invalid string data"
The command contains a faulty character string.
Example: An End-of-Line (not a character but a
flow-control) was received before the final quote
character.
-158,"String data not
allowed"
The command contains a valid character string
at a position which is not allowed. Example: A
text parameter is set in quotation marks,
FORMat:BORder "SWAP"
-
161,"Invalid block data"
The command contains faulty block data.
Example: An End-of-Line signal was received
before the expected number of data had been
received.
-168,"Block data not
allowed"
The command contains valid block data at an
impermissible position.
-
171,"Invalid expression"
The command contains an impermissible
mathematical expression. Example: The
expression contains an uneven number of
parentheses.
-178,"Expression data
not allowed"
The command contains an expression at an
impermissible position.
Table 13: Execution Error - Error in executing the command; sets bit 4 in
the ESR register
Error code from queue
query
Error explanation