R&S PR100 User Manual
SENSe
. :BANDwidth|:BWIDth
The two following commands of identical meaning can be formed. They set
the frequency of the device to 123 MHz:
SENSe:BANDwidth 150E3 = SENSe:BWIDth 150E3
A vertical stroke in indicating the parameters marks alternative possibilities in
the sense of "or". The effect of the command is different, depending on which
parameter is entered.
Example: Selection of parameter for command
SENSe:GCONTrol:MODE FIXed|MGC AUTO|AGC
If the parameter FIXed is selected, the gain is determined by the MGC
voltage. In case of AUTO the gain depends on the signal. The two
parameters MGC and AGC are synonymous for FIXed and AUTO.
[ ] – Square Brackets
Keywords in square brackets can be omitted in the command. The device also
accepts the full command. Parameters in square brackets can also be
optionally inserted into the command or can be omitted.
{ } – Curly Braces
Parameters in braces can be inserted in the command once or several times,
or be omitted altogether.
9.4.2 Common Commands
The common commands are taken from the IEEE 488.2 (IEC 625-2) standard.
A particular command has the same effect on different devices. The headers
of these commands consist of an asterisk "*" followed by three letters. Many
common commands concern the "status reporting system" in Section 9.
Table 17: Common Commands
Command Parameter Query (also|no|only
query)
*CLS no query
*ESE 0 ... 255 also query
*ESR? only query
*IDN? only query
*IST? only query
*OPC also query
*OPT? only query
*PRE 0 ... 255 also query
*RST no query
*SRE 0 ... 255 also query
*STB? only query
To Next Page
Loading...
