Rohde & Schwarz R&S FPL1000 - Page 66

Trying Out the Instrument
R&S
®
FPL1000
66Getting Started 1179.4657.02 ─ 10
the results, we will increase the number of sweep points from the default 1001
to 32001.
a) Press the [Sweep] key on the front panel.
b) Tap the "Sweep Config" softkey in the "Sweep" menu.
c) In the "Sweep Points" field, enter 32001.
d) Close the "Bandwidth" dialog box.
e) Press the [Run Single] key on the front panel to perform a new sweep with
the increased number of sweep points.
Figure 6-14: Zoomed peak with increased number of sweep points
Note that the trace becomes much more precise.
Zooming into the Display