Rohde & Schwarz R&S FSL3 - Page 1095

CALCulate:BTOoth Subsystem (BLUETOOTH, K8) R&S FSL
1300.2519.12 6.336 E-11
CALC:BTO:ACLR:EXC?
Queries the number of exceptions.
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:CFDRift[:MAXimum]?
This command determines the maximum Carrier Frequency Drift.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Carrier Frequency Drift measurement (see
CONFigure:BTOoth:MEASurement command). With all other measurements this
command will lead to a query error.
Example
For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on
page 6.334.
CONF:BTO:MEAS CFDR
Activates the Carrier Frequency Drift measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:CFDR?
Queries the result.
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:CFDRift:RATE?
This command determines the maximum Carrier Frequency Drift per 50 µs.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Carrier Frequency Drift measurement (see
CONFigure:BTOoth:MEASurement command). With all other measurements this
command will lead to a query error.
Example
For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on
page 6.334.
CONF:BTO:MEAS CFDR
Activates the Carrier Frequency Drift measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:CFDR:RATE?
Queries the result.