CONFigure:BTOoth Subsystem (BLUETOOTH, K8) R&S FSL
1300.2519.12 6.358 E-11
CONFigure:BTOoth:BANDwidth|BWIDth:VIDeo:AUTO
This command links the video bandwidth to the settings according to the RF Test Specification.
It is only available for the Adjacent Channel Power measurement (see
CONFigure:BTOoth:MEASurement command).
Note: This setting is only valid for the currently active measurement (see
CONFigure:BTOoth:MEASurement command) and it is independent of the other
Bluetooth measurements.
Parameter
ON | OFF
Example
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS ACLR
Activates the Adjacent Channel Power measurement.
CONF:BTO:BAND:VID:AUTO ON
Switches the VBW coupling on.
Characteristics
*RST value: ON
SCPI: device–specific
Mode
BT
CONFigure:BTOoth:CFSTability:BCOunt
This command sets the number of blocks to be measured.
Note: This command is only available with active Carrier Frequency Stability and Modulation
Accuracy measurement (see CONFigure:BTOoth:MEASurement command).
Parameter
0 to 1,000,000
Example
CONF:BTO:CFST:BCO 1000
Selects 1000 blocks to be measured.
Characteristics
RST value: 200
SCPI: device–specific
Mode
BT
To Next Page
Loading...
