R&S FSL CONFigure:BTOoth Subsystem (BLUETOOTH, K8)
1300.2519.12 6.363 E-11
C
haracteristics
*RST value: 80%
SCPI: device–specific
M
ode
BT
CONFigure:BTOoth:PRATe
This command selects the number of measurement samples (points) per symbol for the
measurement. This command is not avaiable for EDR measurements. For EDR measurements,
this parameter is set to 4 points/symbol and cannot be changed.
Note: The RF Test Specification specifies an oversampling factor of at least 4.
Parameter
2 | 4 | 8 | 16 | 32
Example
CONF:BTO:PRAT 16
Selects 16 points/symbol.
Characteristics
*RST value: 4
SCPI: device–specific
Mode
BT
CONFigure:BTOoth:PTYPe
This command selects the packet type to be measured.
Parameter
DH1 1 slot packet
DH3 3 slot packet
DH5 5 slot packet
AUTO automatic selection of the packet type
Example
CONF:BTO:PTYP DH5
Selects type "5 slot packet".
Characteristics
*RST value: DH1
SCPI: device–specific
Mode
BT
To Next Page
Loading...
