R&S FSL UNIT Subsystem (Power Meter, K9)
1300.2519.12 6.389 E-11
Remote Commands of the Spectrogram
Measurement Option (K14)
This section describes the remote commands for the Spectrogram Measurement option (K14). The
abbreviation SPECM stands for the Spectrogram measurement mode. For details on conventions used
in this chapter refer to section "Notation" on page 6.2 at the beginning of this chapter.
For further information on analyzer or basic settings commands, refer to the corresponding subsystem
in "Remote Commands of the Base Unit" on page 6.5.
This option is available from firmware version 1.60.
Subsystems of the Spectrogram Measurement option (K14)
– "CALCulate Subsystem (SPECM, K14)" on page 6.390
– "INITiate Subsystem (SPECM, K14)" on page 6.407
– "MMEMory Subsystem (SPECM, K14)" on page 6.408
– "TRACe Subsystem (SPECM, K14)" on page 6.409
To Next Page
Loading...
