Remote Commands of the Cable TV Measurements Option (K20) R&S FSL
1300.2519.12 6.410 E-11
Remote Commands of the Cable TV Measurements
Option (K20)
This section describes the remote commands for the Cable TV Measurement option (K20). The
abbreviation CATV stands for the Cable TV operating mode. For details on conventions used in this
chapter refer to section "Notation" on page 6.2 at the beginning of this chapter.
For further information on analyzer or basic settings commands, refer to the corresponding subsystem
in "Remote Commands of the Base Unit" on page 6.5.
This option is available from firmware version 1.30.
Subsystems of the Cable TV Analyzer option (K20)
– "ABORt Subsystem (CATV, K20)" on page 6.411
– "CALCulate Subsystem (CATV, K20)" on page 6.412
– "CONFigure Subsystem (CATV, K20)" on page 6.469
– "DISPlay Subsystem (CATV, K20)" on page 6.474
– "FORMat Subsystem (CATV, K20)" on page 6.479
– "INITiate Subsystem (CATV, K20)" on page 6.480
– "INPut Subsystem (CATV, K20)" on page 6.481
– "INSTrument Subsystem (CATV, K20)" on page 6.482
– "MMEMory Subsystem (CATV, K20)" on page 6.483
– "SENSe Subsystem (CATV, K20)" on page 6.484
– "SETup:TV Subsystem (CATV, K20)" on page 6.509
– "SOURce Subsystem (CATV, K20)" on page 6.511
– "STATus Subsystem (CATV, K20)" on page 6.512
– "TRACe Subsystem (CATV, K20)" on page 6.516
– "TRIGger Subsystem (CATV, K20)" on page 6.517
– "UNIT Subsystem (CATV, K20)" on page 6.520
To Next Page
Loading...
