Rohde & Schwarz R&S FSL3 - Page 1211

CALCulate Subsystem (CATV, K20) R&S FSL
1300.2519.12 6.452 E-11
CALC:DTV:LIM:RES:CSUP?
Performs a lower limit check for the lower limit of the carrier suppression.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
CALCulate:DTV:LIMit:RESult:EVMPeak:LOWer?
This command performs an lower limit check for the error vector magnitude peak in the
Overview measurement.
This command is a query and therefore has no *RST value.
Example
CALC:DTV:LIM:EVMP:LOW 5DB
Sets the lower limit for the error vector magnitude peak to 5 dB.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:DTV:LIM:RES:EVMP:LOW?
Performs an lower limit check for the error vector magnitude peak.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV
CALCulate:DTV:LIMit:RESult:EVMPeak:UPPer?
This command performs an upper limit check for the error vector magnitude peak in the
Overview measurement.
This command is a query and therefore has no *RST value.
Example
CALC:DTV:LIM:EVMP:UPP 1PCT
Sets the upper limit for the error vector magnitude peak to 1%.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:DTV:LIM:RES:EVMP:UPP?
Performs an upper limit check for the error vector magnitude peak.
Characteristics
RST value: –
SCPI: device–specific
Mode
CATV