Rohde & Schwarz R&S FSL3 - Configure Subsystem (CATV, K20)

R&S FSL CONFigure Subsystem (CATV, K20)
1300.2519.12 6.469 E-11
CONFigure Subsystem (CATV, K20)
The CONFigure subsystem contains commands for configuring complex measurement tasks.
The following subsystems are included:
• "CONFigure:ATV Subsystem (CATV, K20)" on page 6.469
• "CONFigure:DTV Subsystem (CATV, K20)" on page 6.472
• "CONFigure:TV Subsystem (CATV, K20)" on page 6.473
CONFigure:ATV Subsystem (CATV, K20)
The CONFigure:ATV subsystem contains commands to configure analog TV measurements.
Commands of the CONFigure:ATV Subsystem
– CONFigure:ATV:CN:MEASurement
– CONFigure:ATV:CSO:MEASurement
– CONFigure:ATV:CTB:MEASurement
– CONFigure:ATV:MEASurement
CONFigure:ATV:CN:MEASurement
This command configures a new carrier or noise measurement with the next sweep for the
Carrier–to–Noise Ratio measurement.
Parameter
CARRier | NOISe
Example
CONF:ATV:MEAS CN
Configures the analog TV Carrier–to–Noise Ratio measurement.
ATV:CN:MEAS:MODE OSER
Sets the Off–Service measurement method.
CONF:ATV:CN:MEAS CARR
Configures a new carrier measurement with the next sweep.
INIT;*OPC
Starts the new noise measurement.
Characteristics
RST value: CARRier
SCPI: device–specific
Mode
CATV