Rohde & Schwarz R&S FSL3 - Display Subsystem (CATV, K20)

DISPlay Subsystem (CATV, K20) R&S FSL
1300.2519.12 6.474 E-11
DISPlay Subsystem (CATV, K20)
The DISPLay subsystem controls the selection and presentation of textual and graphic information as
well as of measurement data on the display.
Commands of the DISPlay Subsystem
– DISPlay[:WINDow<1|2>]:TRACe<1...4>[:STATe]
– DISPlay[:WINDow<1|2>]:TRACe<1...4>:MODE
– DISPlay[:WINDow<1|2>]:TRACe<1...4>:MODE:FREeze[:STATe]
– DISPlay[:WINDow<1|2>]:TRACe<1...4>:MODE:HCONtinuous
– DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y[:SCALe]
– DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y[:SCALe]:AUTO
– DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y[:SCALe]:MODE
– DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y[:SCALe]:RLEVel
– DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y[:SCALe]:RLEVel:OFFSet
– DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y[:SCALe]:RPOSition
– DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y:SPACing
– DISPlay[:WINDow<1|2>]:ZOOM:EPATtern
– DISPlay[:WINDow<1|2>]:ZOOM:EPATtern:STATe
– DISPlay[:WINDow<1|2>]:ZOOM:MERRors
– DISPlay[:WINDow<1|2>]:ZOOM:OVERview
– DISPlay[:WINDow<1|2>]:ZOOM:QUADrant
DISPlay[:WINDow<1|2>]:TRACe<1...4>[:STATe]
The numeric suffixes <1...4> select the trace.
For further details refer to "DISPlay[:WINDow<1|2>]:TRACe<1...6>[:STATe]" on page 6.132.
DISPlay[:WINDow<1|2>]:TRACe<1...4>:MODE
The numeric suffixes <1...4> select the trace.
For further details refer to "DISPlay[:WINDow<1|2>]:TRACe<1...6>:MODE" on page 6.132.
DISPlay[:WINDow<1|2>]:TRACe<1...4>:MODE:FREeze[:STATe]
This command sets the display mode of the constallation diagram.
The numeric suffixes <1|2> are irrelevant.
Parameter
ON The constellation diagram is displayed unchanged, while the I/Q samples are
collected in the background.
OFF The constellation diagram is displayed on basis of the current I/Q samples and, in
continuous sweep mode, is updated with every measurement.