Rohde & Schwarz R&S FSL3 - Page 1235

DISPlay Subsystem (CATV, K20) R&S FSL
1300.2519.12 6.476 E-11
DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y[:SCALe]:RLEVel
The numeric suffixes <1...4> select the trace.
For further details refer to "DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RLEVel" on page
6.135.
DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y[:SCALe]:RLEVel:OFFSet
The numeric suffixes <1...4> select the trace.
For further details refer to "DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RLEVel:OFFSet"
on page 6.135.
DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y[:SCALe]:RPOSition
The numeric suffixes <1...4> select the trace.
For further details refer to "DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RPOSition
(models with tracking generator)" on page 6.136.
DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y:SPACing
The numeric suffixes <1...4> select the trace.
Parameter
LINear | LOGarithmic
For further details refer to "DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y:SPACing" on page 6.134.
DISPlay[:WINDow<1|2>]:ZOOM:EPATtern
This command sets the zoom factor for the Echo Pattern measurement.
The numeric suffixes <1|2> are irrelevant.
Parameter
1 to 20
Example
CONF:DTV:MEAS EPAT
Configures the R&S FSL for the Echo Pattern measurement.
DISP:ZOOM:EPAT 2
Sets the zoom factor for the Echo Pattern measurement.
Characteristics
RST value: 1
SCPI: device–specific
Mode
CATV