R&S FSL SENSe Subsystem (WCDMA, K72)
1300.2519.12 6.585 E-11
Example
CDP:HSDP OFF
Deactivates the HSUPA/DPA channel detection.
Characteristics
RST value: ON
SCPI: device–specific
Mode
WCDMA
[SENSe<1|2>:]CDPower:ICTReshold
This command sets the minimum power threshold for a single channel (channel power
compared to total signal power). Only channels with a signal power above this value are
recognized as active channels.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
–100 dB to 10 dB
Example
CDP:ICTR –10
Sets the minimum power threshold to –10 dB.
Characteristics
RST value: –60 dB
SCPI: device–specific
Mode
WCDMA
[SENSe<1|2>:]CDPower:LCODe[:VALue]
This command defines the scrambling code in hexadecimal format.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
0x0 … 0x5FFF
Example
CDP:LCOD #H2
Defines the scrambling code in hexadecimal format.
Characteristics
RST value: 0
SCPI: device–specific
Mode
WCDMA
To Next Page
Loading...
