R&S FSL SENSe Subsystem (WCDMA, K72)
1300.2519.12 6.587 E-11
Example
CDP:LCOD:SEAR
Starts the automatic scrambling code search.
CDP:LCOD:SEAR:LIST?
Lists the result table of the automatic search sequence.
Characteristics
RST value: –
SCPI: device–specific
Mode
WCDMA
[SENSe<1|2>:]CDPower:LEVel:ADJust
This command adjusts the reference level to the measured channel power. This ensures that
the settings of the RF attenuation and the reference level are optimally adjusted to the signal
level without overloading the R&S FSL or limiting the dynamic range by an S/N ratio that is too
small.
The numeric suffixes <1|2> are irrelevant for this command.
This command is an event and therefore has no *RST value and no query.
Example
CDP:LEV:ADJ
Adjusts the reference level to the measured channel power.
Characteristics
RST value: –
SCPI: device–specific
Mode
WCDMA
[SENSe<1|2>:]CDPower:NORMalize
This command activates and deactivates the elimination of the I/Q offset.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
ON | OFF
Example
CDPower:NORMalize ON
Activates the elimination of the I/Q offset.
Characteristics
RST value: OFF
SCPI: device–specific
Mode
WCDMA
To Next Page
Loading...
