Rohde & Schwarz R&S FSL3 - Page 1347

SENSe Subsystem (WCDMA, K72) R&S FSL
1300.2519.12 6.588 E-11
[
SENSe<1|2>:]CDPower:PREFerence
This command sets the power reference for the relative power displays.
T
he numeric suffixes <1|2> are irrelevant for this command.
Parameter
TOT total power
CPICH power of the common pilot channel
Example
CDP:PREF TOT
Sets the total power as power reference.
Characteristics
RST value: CPICH
SCPI: device–specific
Mode
WCDMA
[SENSe<1|2>:]CDPower:QINVert
This command activates or deactivates the Q inversion.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
ON The sign of the Q–component of the signal is inverted.
OFF The sign of the Q–component of the signal remains unchanged.
Example
CDP:QINV ON
Activates the Q inversion.
Characteristics
RST value: OFF
SCPI: device–specific
Mode
WCDMA
[SENSe<1|2>:]CDPower:RSUMmary
This command sets the view of the Code Domain Result Summary.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
NORmal Some of the most important results are shown in the table on the R&S FSL
display.
EXTended All available result are shown in the table on the R&S FSL display.
Example
CDP:RSUM EXT
Sets the extended view of the Code Domain Result Summary.